EPS 2011-04

5-11

Installing and Connecting the HP Redundant / External Power Supplies

Installation Procedures

Rack mounting a single 630 power supply:

1. Use a #1 Cross-head screwdriver and attach the mounting brackets to the

unit with the included 8-mm M4 screws. The screws must be tightened

sufficiently to provide proper support for the unit in the rack.

Figure 5-4. Attaching mounting brackets for a single unit rack mount

When mounting only one unit, mount the short mounting bracket on the left

side and the long mounting bracket on the right side (recommended

mounting). For the long mounting bracket, a screw driver at least 10 inches

long is recommended.

Be sure to use four screws per side to ensure the weight of the unit is properly

supported.

WARNING For safe reliable installation, only use the screws provided in the

accessory kit to attach the mounting brackets to the unit.

Note The mounting brackets have multiple mounting holes and can be rotated

allowing for a wide variety of mounting options. These include mounting the

unit so that its front face is flush with the face of the rack, as shown in the

illustration above or shifting the location of the brackets toward the rear for

a more balanced installation.

8 mm

M4 screws