EPS 2011-04

5-7

Installing and Connecting the HP Redundant / External Power Supplies

Installation Procedures

■ Do not install the unit in an environment where the operating ambient

temperature might exceed 55°C (131°F).

■ Make sure the air flow around the front and back of the unit is not

restricted. If this unit is placed in a fully enclosed rack, make certain the

ambient temperature inside the rack near the unit does not exceed 55°C

(131°F).

■ For safe operation and to prevent equipment damage, DO NOT connect

EPS, RPS, or power cables to non-supported equipment or in non-

supported configurations.

■ If the HP 610 EPS is actively providing backup power to another

HP 610 EPS, disconnect AC power cord before removing backup power

cables. This will reduce possible sparking and equipment damage.