Installation and Getting Started Guide for HP 600/610/620/630 RPS/EPS 2011-04

5-4
Installing and Connecting the HP Redundant / External Power Supplies
Included Parts
HP 630 RPS/EPS
The HP 630 RPS/EPS has the following components shipped with them:
■ HP 630 RPS/EPS Quick Setup Guide
■ HP 600, 610, 620, and 630 External and/or Redundant Power Supplies
Safety and Regulatory Information sheet
■ HP Switches General Safety and Regulatory booklet
■ Accessory kit
■ One extended mounting bracket, (5003-1446)
■ One Joining bracket, (5183-2053)
■ Two EPS/RPS cables, (5070-0102)
Note The EPS and RPS cables can be used for either EPS or RPS connections.
However, a cable MUST not be installed such that an EPS port is connected
to an RPS port. Make sure to follow the color coding on the switch and
power supply.
■ AC power cord, one of the following:
Japan Power
Cord Warning
(5183-2077)
• one mounting bracket
• 15, 8-mm M4 screws for attaching hardware
• four 5/8-inch number 12-24 screws to attach the unit
to a two post Telco rack
• four rubber feet
Region Power Cord
Part Number
Region Power Cord
Part Number
United States/Canada/Mexico
Taiwan
Japan
Europe
United Kingdom/Hong Kong/Singapore
Australia/New Zealand
8121-0973
8121-0941
8120-5342
8120-5336
8120-5334
8121-0857
China
Denmark
Switzerland
South Africa/India
Israel
Thailand
8121-1034
8120-5340
8120-5339
8120-5341
8121-1009
8121-0671