EPS 2011-04

5-14

Installing and Connecting the HP Redundant / External Power Supplies

Installation Procedures

After attaching the joining brackets, join the two units together as in the

following illustration, Figure 5-7.

Slide the two units together as shown in the following illustration.

Figure 5-7. Joining the two units together

Secure the two units together using the remaining 8mm M4 screws

Figure 5-8. Securing the two units together

Insert the screws

in the top

Turn the units over and

insert the screws in

the bottom

Use caution when

turning the units over

so as not to damage

the rear ports

8 mm

M4 screws