EPS 2011-04

5-13

Installing and Connecting the HP Redundant / External Power Supplies

Installation Procedures

Rack mounting two power supplies side-by-side:

Note When attaching the joining brackets, attach them with the fascia tab facing to

the front of the unit. In this configuration the long mounting bracket is not

needed.

Figure 5-6. Attaching joining brackets and mounting brackets for rack mounting

two units

To ensure a safe and secure mounting, use all the screws specified for

attaching the joining brackets to the unit and attaching the joining brackets

together. All 8-mm M4 screws should be installed to a torque of 15 in-lbs. Use

a Cross-head screwdriver and attach the short mounting brackets and the

joining brackets to the unit with the included 8-mm M4 screws as shown in

Figure 5-6.

Fascia tab

8 mm

M4 screws

8 mm

M4 screws