EPS 2011-04

5-10

Installing and Connecting the HP Redundant / External Power Supplies

Installation Procedures

Figure 5-2. Example two, connecting mounting brackets

Note The mounting brackets have multiple mounting holes and can be rotated

allowing for a wide variety of mounting options. These include mounting the

unit so that its front face is flush with the face of the rack, or mounting it in a

more balanced position as shown in the illustration above.

2. Hold the unit with attached brackets up to the rack and move it vertically

until rack holes line up with the bracket holes, then insert and tighten the

four number 12-24 screws holding the brackets to the rack.

Figure 5-3. Mounting into a rack