Installation and Getting Started Guide for HP 600/610/620/630 RPS/EPS 2011-04

1-3
Introducing the HP 600 Redundant and External Power Supplies
Back of the Unit
Back of the Unit
Device Connected
(green – over-laid
with the port
number)
On There is a valid connection to a device.
Off There is no device connected to the port.
Power Status
(green)
On The unit is supplying power to a connected device.
Off One of these conditions exists:
• There is no connected device.
• A connected RPS device does not require power.
• A connected EPS device has not successfully communicated for EPS power.
Blinking* One of these conditions exists:
• The RPS power is not available to the connected device because a higher
priority port is using it.
• When the LED is blinking simultaneously with the Fault LED, there is a fault
condition on the port.
* The blinking behavior is an on/off cycle once every 1.6 seconds, approximately.
†
Specific fault conditions can be viewed by checking switch log files.
Table 1-1. HP 600 RPS/EPS
LED State Meaning
EPS 1
RPS 5
R5
RPS 3
R3R1
Power Status
RPS 1
R2
RPS 2
RPS 4
R4
R6
RPS 6
E1
E2
EPS 2
Device
Connected
Pow er
Status
Device Connected
RPS port LEDs
HP 600 RPS/EPS
RPS ports
AC power
connector
EPS port LEDs
EPS ports
RPS 1
RPS 6