9.6 HP Pay per use Utility Meter II Software Installation and Configuration Guide (October 2012)

Installation and Configuration Guide
Chapter 1: Introduction
What is New for Version 9.6
Version 9.6 of the Utility Meter software includes the following:
l Updates to the Utility Meter GUI.
What Has Been Fixed in Version 9.6
Version 9.6 of the Utility Meter software includes the following fixes:
l QC 3138- Test vpar6.1 migration between multiple VSP and missing data, test adding new
vpar6.1
l QC 3139- Verify if the portal is down the files are resent, and there is no partial collection
l QC-1964 GUI – Error directory in File-viewer tab and troubleshoot to include error files from
"$UC_HOME/data/error"
l QC-1965 GUI – GUI-Error directory information in troubleshoot tab display table
l SD2 sanity testing for Skymaster Poulson
l QC 3150 Forced collection gives empty data (no usage data) for SD2 and vPar6.1 devices
l QC-1665"umadmin collect" does not force the collection for PPUSD1 devicetype
Known Issues
Version 9.6 of the Utility Meter software has the following known issues:
l The umadmin collect -all command always runs assuming -nowait was specified.
l In the GUI you can receive an "Internal Server Error" due to a timeout if an action takes more
than 3 to 5 minutes (for example, Trying to add a 3PAR array with an invalid IP address).
Recommended Hardware
The Utility Meter 9.6 software requires a ProLiant DL 320 server. 4GB of memory is required, a
160GB SATA disk and a DVD-R drive.
Caution: The hardware used to run the Utility Meter 9.6 software must be used exclusively for the
Utility Meter software application. No other software applications or services are allowed
on the Utility Meter hardware.
Supported PPU Servers
The following are supported by PPU:
l HP Superdome 1
l HP Superdome 2 16s
HP Pay per use Utility Meter II Software (9.6)Page 9 of 65