9.6 HP Pay per use Utility Meter II Software Installation and Configuration Guide (October 2012)

Networking details for PPU Onboard
Administrators
Fill out the table below for each Onboard Administrator (OA) to be monitored using GSOAP. If more
than 10 PPU OAs are to be monitored, please duplicate this page and complete one entry for each
OA.
Note:The username/password must have GSOAP access for all of the hardware, including the OA,
device bays, and interconnect device bays.
Question Answer
IP address or hostname of the OA to be
monitored under a PPU contract.
1.
2.
3.
4.
5.
Username/password[1] of an account for this
OA with GSOAP access for all the hardware.
1.
2.
3.
4.
5.
[1]
For security reasons, this information can be made available at the time of installation only.
Networking details on the PPU WBEM
Partitions/Servers
Fill out the table below for each partition/server (an nPar or vPar VSE partition in a cell based
server) to be monitored using PPU WBEM. If more than 10 PPU WBEM partition/servers are to be
monitored, please duplicate this page and complete one table for each partition/server.
Note:The username/password must belong to a group with remote WBEM access permission.
Question Answer
IP address or hostname of the partition/server
to be monitored under a PPU contract. The
partition/server should have the appropriate
WBEM providers already installed.
1.
2.
3.
4.
5.
HP Pay per use Utility Meter II Software (9.6)Page 57 of 65
Installation and Configuration Guide
Appendix A. Site Preparation Form for Pay Per Use