9.6 HP Pay per use Utility Meter II Software Installation and Configuration Guide (October 2012)

Installation and Configuration Guide
Chapter 3: Configuring Devices
devices or the Device Serial Number-Product ID for URS devices of the device you
want to verify.
Figure 3.3. View My List Page
6. You should see a page similar to the following page that shows when the last usage report was
received. If you see the following page, then the PPU partition is properly connected to the
UPS portal through the Utility Meter.
Figure 3.4. End-to-End Connectivity Verification Page
If you do not see a page similar to the one in Step 6, then there is a connectivity problem between
the device and the UPS portal.
If you are having trouble with the connectivity verification, follow the information in Chapter 4:
“Troubleshooting the Utility Meter”.
Delete Devices
Deleting Devices from the GUI
For PPU devices, individual devices can be deleted. For URS devices, you can delete either a
single storage array or all arrays managed by one CV instance.
To delete a device using the GUI, complete the following steps:
1. Open a browser and enter the Utility Meter's fully qualified domain name into the address bar.
2. Log on as user umeter (default password: h.lnxmtr).
HP Pay per use Utility Meter II Software (9.6)Page 42 of 65