9.6 HP Pay per use Utility Meter II Software Installation and Configuration Guide (October 2012)

Installation and Configuration Guide
Chapter 3: Configuring Devices
Note: This test can only performed using the umadmin command.
1. Log on to the Utility Meter as user umeter (default password: h.lnxmtr).
2. Enter the following command:
$ umadmin test -name deviceName
where deviceName is the name of the device you want to test connectivity to.
The results of the connectivity test will be displayed.
Running the End-to-End Test
This will test the connectivity of the Utility Meter to each device, and then test the connectivity of
the Utility Meter to HP. The umadmin e2etest tests connectivity for all device types, but only
generates a usage report for PPUOA devices. If no PPUOA devices exist, it generates a usage
report for the meter Heartbeat. A Heartbeat is sent every hour to HP to verify the meter is
functioning. See section “Checking the Web Portal for Data Arrival” to verify that usage reports
arrived at the UPS portal.
Use the following procedure to verify connectivity of the Utility Meter to all devices and to HP:
Note: This test can only performed using the umadmin command.
1. Log on to the Utility Meter as user umeter (default password: h.lnxmtr).
2. Enter the following command:
$ umadmin e2etest e2etest will be run for the following devices:
1.deviceNamePPUOA
2.deviceNamePPUPARTITION
3.deviceNameURSEVA
4.deviceNameURSXP
5.deviceNameURS3PAR
6.vpar6.1
7.vsp
This may take several minutes to complete.
Current date-time is: 06/22/2011 07:36 CDT
Device Connectivity test:
Connectivity status for device deviceNamePPUOA is: successful
Connectivity status for device deviceNamePPUPARTITION is:
successful
Connectivity status for device deviceNameURSEVA is: successful
Connectivity status for device deviceNameURSXP is: successful
Connectivity status for device deviceNameURS3PAR is: successful
Connectivity status for vpar6.1
Connectivity status for vsp
Device collection test for PPUOA device:
Collection status for device deviceNamePPUOA is: successful.
Testing connectivity to HP:
OK
Transmission status for device deviceNamePPUOA is successful
Generating a Usage Report
The umadmin collect command can be used to force the meter to generate a collection, create a
HP Pay per use Utility Meter II Software (9.6)Page 39 of 65