Manualshelf

9.6 HP Pay per use Utility Meter II Software Installation and Configuration Guide (October 2012)

ManualsBrandsHP ManualsSoftwareHP Pay per use (PPU) Software
31323334353637383940
Installation and Configuration Guide
Chapter 3: Configuring Devices
n Is URS Device? check box – A usage report will be created for each array that has this
check box selected. It provides a way to temporarily stop usage reports from being created.
5. Click Modify.
Modify a 3PAR Storage Array from the Command Line
To modify a 3PAR array using the command line, complete the following steps:
1. Log on to the Utility Meter as user umeter (default password: h.lnxmtr).
2. Modify the 3PAR array using the following command:
$ umadmin moddev -name deviceName -type URS3PAR -address IPAddress
-enabled enabled [-info info]
where deviceName is the name of the 3PAR array to be modified, IPAddress is either the
fully qualified domain name or IP address of the 3PAR InForm OS managing the device, and
enabled is true or false to indicate if URS reports are to be created for the array. The -
info parameter is optional.
After entering the information, you should see the following output:
Device deviceName modified successfully.
3. Verify the 3PAR array was modified by listing the devices that are being monitored by the
Utility Meter:
$ umadmin list
List of devices -
Device Name = deviceName
Type = URS3PAR
Address = IPAddress
Device ID = deviceID
Info = info
Model = model
Serial = serial
You should see the 3PAR array listed with the modified values.
Verify Connectivity
There are three steps to verifying connectivity of the Utility Meter:
l Testing connectivity from a device to the Utility Meter (see section: “Testing Connectivity from a
Device to the Utility Meter”)
l Running the end-to-end connectivity test (see section: “Running the End-to-End Test”)
l Checking the web portal for data arrival (see section: “Checking the Web Portal for Data Arrival”)
Testing Connectivity from a Device to the Utility
Meter
To test that the Utility Meter can successfully connect to the device, complete the following steps:
HP Pay per use Utility Meter II Software (9.6)Page 38 of 65