9.6 HP Pay per use Utility Meter II Software Installation and Configuration Guide (October 2012)

Installation and Configuration Guide
Chapter 3: Configuring Devices
n New CVAE Instance Info – (optional text to be associated with this CVAE) Enter a
description for the CVAE.
n XP CLI Location – Enter the directory path to the instance of CVAE CLI on the Utility
Meter that will be used for the XP disk array being added.
n Is URS Device? check box – A usage report will be created for each array that has this
check box selected. It provides a way to temporarily stop usage reports from being created.
5. Click Modify.
Modify an XP Storage Array from the Command Line
To modify an XP array using the command line complete the following steps:
1. Log on to the Utility Meter as user umeter (default password: h.lnxmtr).
2. Modify the XP array using the following command:
$ umadmin moddev -name deviceName -type URSXP -address IPAddress -
path path -enabled enabled [-info info]
where deviceName is the name of the XP array to be modified, IPAddress is either the fully
qualified domain name or IP address of the CVAE managing the device, path is the directory
path to the CLI instance to be used for the XP, and enabled is true or false to indicate if
URS reports are to be created for the array. The -info parameter is optional.
After entering the information, you should see the following output:
Device deviceName modified successfully.
3. Verify the XP array was modified by listing the devices that are being monitored by the Utility
Meter:
HP Pay per use Utility Meter II Software (9.6)Page 36 of 65