9.6 HP Pay per use Utility Meter II Software Installation and Configuration Guide (October 2012)

Installation and Configuration Guide
Chapter 3: Configuring Devices
1. Log on to the Utility Meter as user umeter (default password: h.lnxmtr).
2. Add the XP array using the following command:
$ umadmin adddev -name deviceName -type URSXP -address IPAddress -
username userName -path path -model model -serial serial [-info
info]
where path is the path to CVAE CLI, model is the model number of the disk array, serial is
the serial number of the array, and IPAddress is either the fully qualified domain name or IP
address of the CVAE managing the device. The -info parameter is optional.
3. When prompted, enter the password for the specified userName required to log on to the
CVAE.
After entering the password, you should see the following output:
Device deviceName added successfully.
4. Verify the disk array was added by listing the devices that are being monitored by the Utility
Meter:
$ umadmin list
List of devices -
Device Name = deviceName
Type = URSXP
Address = IPAddress
Device ID = deviceID
Info = info
Path = path
Model = model
Serial = serial
You should see the XP array that you added in Step 2 listed.
Adding a 3PAR Storage Array
Add a 3PAR storage array from the GUI
To add a 3PAR array using the GUI, complete the following steps:
1. Open a browser and enter the Utility Meter's fully qualified domain name into the address bar.
2. Log on to the Utility Meter as user umeter (default password: h.lnxmtr).
3. Select the Device Management tab and click Add Device.
4. Select Storage Device - 3PAR from the Device Type drop-down list.
5. Enter the information about the 3PAR array into the Add Device form:
HP Pay per use Utility Meter II Software (9.6)Page 30 of 65