9.6 HP Pay per use Utility Meter II Software Installation and Configuration Guide (October 2012)

Installation and Configuration Guide
Chapter 3: Configuring Devices
n Password for CV EVA – Enter the password that can be used to log on to the CV EVA.
Contact the System Administrator or HP engineer who installed CV EVA for the password.
6. Click Add.
7. Verify the EVA array was added by checking for it in the left menu tree.
Add an EVA Storage Array from the Command Line
To add an EVA array using the command line, complete the following steps:
1. Log on to the Utility Meter as user umeter (default password: h.lnxmtr).
2. Add the EVA array using the following command:
$ umadmin adddev -name deviceName -type URSEVA -address IPAddress -
username userName -path path [-info info]
where path is the path to SSSU, and IPAddress is either the fully qualified domain name or
IP address of the CV EVA managing the device. The -info parameter is optional.
3. When prompted, enter the password for the specified userName required to log on to the CV
EVA.
After entering the password, you should see the following output:
Device deviceName added successfully.
4. Verify the EVA array was added by listing the devices that are being monitored by the Utility
Meter:
$ umadmin list
List of devices -
Device Name = deviceName
Type = URSEVA
Address = IPAddress
Device ID = deviceID
Info = info
Path = path
You should see the EVA that you added in Step 2 listed.
Adding an XP Storage Array
Add an XP Storage Array from the GUI
To add an XP array using the GUI, complete the following steps:
1. Open a browser and enter the Utility Meter's fully qualified domain name into the address bar.
2. Log on to the Utility Meter as user umeter (default password: h.lnxmtr).
3. Select the Device Management tab and click Add Device.
4. Select Storage Device - XP Array from the Device Type drop-down list.
HP Pay per use Utility Meter II Software (9.6)Page 28 of 65