9.6 HP Pay per use Utility Meter II Software Installation and Configuration Guide (October 2012)

Installation and Configuration Guide
Chapter 3: Configuring Devices
Adding an EVA Storage Array
Add an EVA Storage Array from the GUI
To add an EVA array using the GUI, complete the following steps:
1. Open a browser and enter the Utility Meter's fully qualified domain name into the address bar.
2. Log on to the Utility Meter as user umeter (default password: h.lnxmtr).
3. Select the Device Management tab and click Add Device.
4. Select Storage Device - EVA Array from the Device Type drop-down list.
5. Enter the information about the EVA array into the Add Device form:
n CV EVA Instance IP/Hostname – Enter either the IP address or hostname of the EVA
Command View server. If CV EVA and CVAE are installed on the same system, do not use
the same hostname for both in this field. In case DNS is enabled on the network segment for
the URS environment, use the short hostname for the CV EVA instance and the long
hostname for the CVAE instance or vice versa. Or you can use the short/long hostname for
CV EVA and the IP address for CVAE or vice versa.
n CV EVA Instance Info – Enter a description for the CV EVA (optional text to be associated
with this device).
n EVA Array Name – Enter the user-friendly name of the EVA disk array.
n SSSU Location – Enter the directory path to the instance of SSSU that will be used for the
EVA disk array being added.
n Username for CV EVA – Enter the username that can be used to log on to the CV EVA.
Contact the System Administrator or HP engineer who installed CV EVA for the username.
HP Pay per use Utility Meter II Software (9.6)Page 27 of 65