9.6 HP Pay per use Utility Meter II Software Installation and Configuration Guide (October 2012)

Installation and Configuration Guide
Chapter 2: Installing and Configuring the Utility Meter Software
10. Enter 1 to configure the hostname.
Enter the fully qualified domain name and then enter y to confirm.
11. Enter 2 to configure the network parameters. You can perform either a static or DHCP
configuration. Which you choose will depend on your network:
n Static Configuration:
Enter 1 for a static configuration and enter the following parameters:
o
IP Address
o
Net Mask Address
o
Gateway Address
o
DNS #1 Address
o
DNS #2 Address (optional)
Enter y to confirm your settings. The Utility Meter Ethernet interface will be restarted to
update to the new settings.
n DHCP Configuration:
Enter 2 for a DHCP configuration.
DHCP configures a new IP address, and then the Utility Meter Ethernet interface will be
restarted to update to the new settings.
Warning: Before switching to DHCP, make sure that DHCP services are set up and
running. If DHCP is not set up and running, the Utility Meter CLI/GUI will hang.
12. Log out of iLO:
a. Log out of the Remote Console window, by typing exit, then close the Remote Console
by clicking Close.
b. Close the Virtual Media Applet window.
c. Log out of iLO by clicking the Log out link.
Configure the Utility Meter Parameters
Except for the initial setting of hostname and network type, which must be done using umadmin
configure (see section: Installing Using Integrated Lights-Out, Step 9), the Utility Meter software
can be configured using the GUI or by using the umadmin configure command. The following
values must be configured before any data can be sent to HP:
l SMTP (email) or HTTPS transport
l Customer contact email address
l Timezone
l Date and time
HP Pay per use Utility Meter II Software (9.6)Page 18 of 65