9.3 HP Pay per use Utility Meter II Software Installation and Configuration Guide (July 2011)

NOTE: The username/password must have GSOAP access for all of the hardware, including the OA,
device bays, and interconnect device bays.
AnswerQuestion
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
IP address or hostname of the OA to be monitored under a PPU
contract.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Username/password
1
of an account for this OA with GSOAP
access for all the hardware.
1 For security reasons, this information can be made available at the time of installation only.
A.2 Networking details on the PPU WBEM Partitions/Servers
Fill out the table below for each partition/server (an nPar or vPar VSE partition in a cell based server) to be
monitored using PPU WBEM. If more than 10 PPU WBEM partition/servers are to be monitored, please
duplicate this page and complete one table for each partition/server.
NOTE: The username/password must belong to a group with remote WBEM access permission.
AnswerQuestion
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
IP address or hostname of the partition/server to be monitored
under a PPU contract. The partition/server should have the
appropriate WBEM providers already installed.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Username/password
1
of an account for this partition/server with
WBEM access.
1 For security reasons, this information can be made available at the time of installation only.
50 Site Preparation Form for Pay Per Use