9.3 HP Pay per use Utility Meter II Software Installation and Configuration Guide (July 2011)

See Section 3.3.4: “Checking the Web Portal for Data Arrival” to verify that usage report arrived at the UPS
portal.
WARNING! The umadmin collect command does not work for PPUSD1 devices. See “Known Issues”.
3.3.4 Checking the Web Portal for Data Arrival
IMPORTANT: To view usage reports using the UPS portal, you must first generate a usage report on the
Utility Meter system. See Section 3.3.2: “Running the End-to-End Test” for details about generating a usage
report. For both HTTPS and email data transport, there may be approximately a 30 minute delay for PPU
devices and up to a two hour delay for URS devices (if not using the umadmin collect command) between
the time the usage report is generated and when it can be viewed on the UPS portal. For email data transport,
the delay can be longer due to the number of "hops" in the email routing before the data arrives at HP.
You can verify that usage reports have arrived at the Utility Pricing Solutions (UPS) Web portal by performing
the following procedure:
1. Sign-in to the UPS portal at: http://www.hp.com/go/payperuse.
2. You need to add your device(s) to the UPS portal first. In the UPS portal Welcome page, click the
Update my list link, then the .
38 Configuring Devices