9.3 HP Pay per use Utility Meter II Software Installation and Configuration Guide (July 2011)

Use the following procedure to verify connectivity of the Utility Meter to all devices and to HP:
NOTE: This test can only performed using the umadmin command.
1. Log on to the Utility Meter as user umeter (default password: h.lnxmtr).
2. Enter the following command:
$ umadmin e2etest
e2etest will be run for the following devices:
1.deviceNamePPUOA
2.deviceNamePPUPARTITION
3.deviceNameURSEVA
4.deviceNameURSXP
5.deviceNameURS3PAR
This may take several minutes to complete.
Current date-time is: 06/22/2011 07:36 CDT
Device Connectivity test:
Connectivity status for device deviceNamePPUOA is: successful
Connectivity status for device deviceNamePPUPARTITION is: successful
Connectivity status for device deviceNameURSEVA is: successful
Connectivity status for device deviceNameURSXP is: successful
Connectivity status for device deviceNameURS3PAR is: successful
Device collection test for PPUOA device:
Collection status for device deviceNamePPUOA is: successful.
Testing connectivity to HP:
OK
Transmission status for device deviceNamePPUOA is successful
3.3.3 Generating a Usage Report
The umadmin collect command can be used to force the meter to generate a collection, create a usage
report, and send it to HP for either all devices or a single device. The umadmin collect command has
two variations:
• umadmin collect -all will generate a usage report for all devices and return the report IDs if
successful.
• umadmin collect -name deviceName [-nowait], will generate a usage report for the specified
deviceName, return the report ID if successful and wait for the report to be transmitted to HP. If the
optional -nowait parameter is used, the umadmin collect command will not wait for transmission
of the report to HP.
3.3 Verifying Connectivity 37