9.3 HP Pay per use Utility Meter II Software Installation and Configuration Guide (July 2011)

You should see the EVA listed with the modified values.
3.2.3 Modifying an XP Storage Array
3.2.3.1 Modifying an XP Storage Array from the GUI
Use the following procedure to modify an XP array using the GUI:
1. Open a browser and enter the Utility Meter's fully qualified domain name into the address bar.
2. Log on to the Utility Meter as user umeter (default password: h.lnxmtr).
3. Select the Device Management tab, select the device to be modified and click Modify Device.
4. The following information can be modified using the Modify Devices form:
• New CVAE Instance Info – (optional text to be associated with this CVAE) Enter a description for
the CVAE.
• XP CLI Location – Enter the directory path to the instance of CVAE CLI on the Utility Meter that will
be used for the XP disk array being added.
• Is URS Device? checkbox – A usage report will be created for each array that has this box checked.
It provides a way to temporarily stop usage reports from being created.
5. Click Modify.
3.2.3.2 Modifying an XP Storage Array from the Command Line
Use the following procedure to modify an XP array using the command line:
1. Log on to the Utility Meter as user umeter (default password: h.lnxmtr).
2. Modify the XP array using the following command:
$ umadmin moddev -name deviceName -type URSXP -address IPAddress
-path path -enabled enabled [-info info]
where deviceName is the name of the XP array to be modified, IPAddress is either the fully qualified
domain name or IP address of the CVAE managing the device, path is the directory path to the CLI
instance to be used for the XP, and enabled is true or false to indicate if URS reports are to be created
for the array. The -info parameter is optional.
After entering the information, you should see the following output:
34 Configuring Devices