9.3 HP Pay per use Utility Meter II Software Installation and Configuration Guide (July 2011)

Device deviceName added successfully.
4. Verify the EVA array was added by listing the devices that are being monitored by the Utility Meter:
$ umadmin list
List of devices -
Device Name = deviceName
Type = URSEVA
Address = IPAddress
Device ID = deviceID
Info = info
Path = path
You should see the EVA that you added in Step 2 listed.
3.1.3 Adding an XP Storage Array
3.1.3.1 Adding an XP Storage Array from the GUI
Use the following procedure to add an XP array using the GUI:
1. Open a browser and enter the Utility Meter's fully qualified domain name into the address bar.
2. Log on to the Utility Meter as user umeter (default password: h.lnxmtr).
3. Select the Device Management tab and click Add Device.
4. Select Storage Device - XP Array from the Device Type drop-down list.
5. Enter the information about the XP array into the Add Device form:
• CVAE Instance IP/Hostname – Enter either the IP address or hostname of the CVAE server. If CV
EVA and CVAE are installed on the same system, do not use the same hostname for both in this
field. In case DNS is enabled on the network segment for the URS environment, use the short
hostname for the CV EVA instance and the long hostname for the CVAE instance or vice versa.
Or you can use the short/long hostname for CV EVA and the IP address for CVAE or vice versa.
• XP Device Name – Enter the user-friendly name to be used for the disk array.
28 Configuring Devices