9.3 HP Pay per use Utility Meter II Software Installation and Configuration Guide (July 2011)

3.1.1.2 Adding a PPU WBEM Partition/Server from the Command Line
Use the following procedure to add a PPU WBEM Partition/Server using the command line:
1. Log on to the Utility Meter as user umeter (default password: h.lnxmtr).
2. Add the PPU WBEM Partition/Server using the following command:
$ umadmin adddev -name deviceName -type deviceType -address IPAddress
-username userName [-info info]
where deviceType is PPUOA for a PPU Onboard Administrator, PPUPARTITION for Superdome 2,
or PPUSD1 for Superdome 1 or Integrity Server, and IPAddress is either the device's fully qualified
domain name or IP address. The -info parameter is optional.
3. When prompted, enter the password for the root user of the PPU WBEM Partition/Server. After entering
the password, you should see the following output:
Device deviceName added successfully.
4. Verify the device was added by listing the devices that are being monitored by the Utility Meter:
$ umadmin list
List of devices -
Device Name = deviceName
Type = deviceType
Address = IPAddress
Device ID = deviceID
Info = info
You should see the device that you added in Step 2 listed.
3.1.2 Adding an EVA Storage Array
3.1.2.1 Adding an EVA Storage Array from the GUI
Use the following procedure to add an EVA array using the GUI:
1. Open a browser and enter the Utility Meter's fully qualified domain name into the address bar.
2. Log on to the Utility Meter as user umeter (default password: h.lnxmtr).
3. Select the Device Management tab and click Add Device.
4. Select Storage Device - EVA Array from the Device Type drop-down list.
5. Enter the information about the EVA array into the Add Device form:
26 Configuring Devices