9.2 HP Pay per use Utility Meter II Software Installation and Configuration Guide (December 2010)

# umadmin list
List of devices -
Device Name = deviceName
Type = PPUOA
Address = deviceAddress
Device ID = deviceID
Collection Status = New Device, not yet collected
Submission Status = New Device, not yet collected
Service Name = Utility_Meter_Configuration_Collection
Device Name = deviceName
Type = PPUPARTITION
Address = deviceAddress
Device ID = deviceID
Collection Status = New Device, not yet collected
Submission Status = New Device, not yet collected
Service Name = Utility_Meter_Configuration_Collection
You should see the partition that you added in Step 3 listed.
3.2.2 Adding PPU Partitions from the GUI
Use the following procedure to add a PPU partition using the GUI:
1. On the Utility Meter, open a browser and enter the Utility Meter's fully qualified domain name into the
address bar.
2. Login to the Utility Meter as user umeter (default password: h.lnxmtr).
3. Select the Device Management tab.
4. Enter the information about the PPU partition into the Add Device form:
• Device Name
• Device Type – Select PPUPARTITION for Superdome 2, or PPUSD1 for Superdome 1 or Integrity
Server.
• Address (IP or FQDN)
• Username
• Password
5. Click Submit.
6. Verify the PPU partition was added by checking the List Devices table. You should see the PPU partition
that you added in Step 4 listed.
3.2 Adding PPU Partitions 23