8.16 HP Utility Meter User's Guide (June 2010)

tcp 0 0 *.5989 *.* LISTEN
4.7.4 Test Connection from PPU Partition to UPS Web Portal
IMPORTANT: To view test reports using the UPS portal, you must first generate a test report on the Utility
Meter system. See Section 3.6.2: “Device Connection” for details about generating a test report. For both
HTTPS and email data transport, there will be approximately a 30 minute delay between the time the test
report is generated and when it can be viewed on the UPS portal. For email data transport, the delay can
be longer due to the number of "hops" in the email routing before the data arrives at HP.
You can test the connection from a PPU partition to the Utility Pricing Solutions (UPS) Web portal by performing
the following procedure:
1. Sign-in to the UPS portal at: http://www.hp.com/go/payperuse (See Section 1.6: “Utility Pricing
Solutions Web Portal” for details.)
2. In the UPS portal Welcome page, click the End-to-end connectivity verification link on
the left-hand side.
Figure 4-1 UPS Portal Welcome Page
84 Verifying Utility Meter Operation