HP Data Protector A.06.00 additional writers and HP StorageWorks Disk Array XP support for Microsoft Volume Shadow Copy Service integration

Table 5 Backup options
DescriptionOption
System on which the application runs. In cluster environments, specify
the virtual server hostname (rather than the physical node hostname).
Application
system
System to which your data will be backed up.
Backup
system
Select Use Hardware Provider if you want to perform instant recovery.
Provider
Select this option to perform a ZDB to disk or ZDB to disk+tape and
leave the replica on a disk array for instant recovery.
If this option is not set, you cannot perform instant recovery from the
replica created or reused in this session.
Track the
replica for
instant
recovery
Data Protector checks whether the individual components can be
selectively restored using the instant recovery functionality. A check
detects, whether there are more than one component on the volume
and whether there is any data besides component’s data. If the check
fails, the instant recovery session will fail.
There are three configuration check modes:
• Strict: If any file or folder on the volume does not belong to the
component, the disk backup or instant recovery fails.
• Non-Strict: If any folder on the volume does not belong to the
component, the disk backup or instant recovery fails.
• Disabled: A check detects whether there are more than one
component on the volume or there is any data besides
component’s data, but the session will not fail.
IMPORTANT:
If the configuration check is disabled for an instant recovery,
you will lose the data that does not belong to a component, but
resides on the same volume as the component.
Configuration
check mode
Integrating the Data Protector ZDB integrations and Microsoft Volume Shadow Copy Service92