HP Data Protector A.06.00 additional writers and HP StorageWorks Disk Array XP support for Microsoft Volume Shadow Copy Service integration

Throttles down the consistency check to lessen impact on restore performance.
Set the number of input/output operations, after which the check is stopped for
one second.
VSS_EXCHANGE_2007_SPECIFIC_OPTIONS
-appsrv ClientName
Specifies the system to which the components are restored. If not specified, the
components are always restored to the server from where they were backed up.
Note that all objects in one restore session must be restored to the same system.
-target_tree TargetStoreName
Specifies the target component to which the source component will be restored
and enables you to restore a subcomponent to a different component than the
one from which it was backed up. This option can be used only once for each
-tree option and cannot be specified together with -exch_RSG.
TreeName and its TargetStoreName pair must always be fully expanded
subcomponents representing an Exchange store or logs. See also the Exchange
2007 examples. To get a list of available targets on a specific host, run the
command:
vssbar -appsrv:HostName -perfom:browse -all
Potential targets can be identified by the string “RESTOREMODE = 1”.
NOTE: You cannot restore only a store without logs to a different location. If you
specify a target store for an original store, you must also specify logs with an
additional -tree TreeName -target_tree TargetStoreName pair.
The option must be specified together with -target_dir.
-exch_RSG LinkedStoreName
Creates a new Recovery Storage Group (RSG) and links it to LinkedStoreName.
This option can be used only once for each -tree option and cannot be specified
together with -target_tree. Only one storage group per session can be
restored with this option due to an Exchange limitation. LinkedStoreName
and its TreeName pair must always be fully expanded subcomponents,
representing an Exchange store or logs. See also the Exchange 2007 examples.
IMPORTANT: If the RSG already exists, it is removed and a new one is created.
Any existing data in it will be lost. NOTE: You cannot restore only a store without
logs to a different location. If you specify a target store for an original store, you
must also specify logs with an additional -tree TreeName -target_tree
TargetStoreName pair.
The option must be specified together with -target_dir.
-target_dir Directory
Restoring data and performing instant recovery using Data Protector CLI142