HP Data Protector A.06.00 additional writers and HP StorageWorks Disk Array XP support for Microsoft Volume Shadow Copy Service integration

3. In the Source property page, specify writers and/or components for recovery.
Select the configuration check mode. For more information, see “Configuration
check” on page 81.
To perform additional steps after the instant recovery before recovering the
database, select the No recovery option. Data Protector will not perform a
database recovery and you can finish the recovery steps (such as applying
transaction logs) later on manually.
If the option is not selected, all recovery steps are finished. In such a case,
additional tasks cannot be performed.
This option is available only for the Microsoft Exchange Server 2007 writer. It
is not supported for Microsoft Exchange writer, where the transaction logs are
always applied.
Exchange Server Writer: Optionally, to specify options for the consistency check
of a Microsoft Exchange writer, right-click the writer and click Additional options.
You can perform point-in-time or rollforward restore of Microsoft Exchange Server
writer. For more information, see “Microsoft Exchange Server writer instant
recovery specifics” on page 120.
Exchange Server 2007 Writer:
If you restore an LCR or CCR copy to the original location, note that restore will
be performed to the original database (Exchange Information Store) and not to
the database copy (Exchange Replication Service).
To perform restore to a different location:
a. Right-click a storage group, a store, or logs and click Restore as.
Note that it could take some time for the Restore as dialog to display. The
time depends on the number of the VSS clients in the cell and the available
storages on the clients.
b. In the MS Exchange Additional options dialog box, select the target location
for the components you want to restore: target server, target storage group,
and target stores. For description of the available options, see Table
7 on page 115.
Optionally, specify the mount point for the storage group to be restored in
Mount backup volume to the path. Click Browse to specify the desired mount
point. By default, the storage group is mounted to the C:\Omni_Mnt
directory. Note that the mount point can be specified only for the storage
group and not for a specific store.
Click OK.
HP Data Protector A.06.00 additional writers and HP StorageWorks Disk Array XP
support for Microsoft Volume Shadow Copy Service integration 125