Backup and Restore Of Tru64 Cluster Server

HP OpenView Storage Data Protector
3. Installing Data Protector Agents on Tru64 Cluster
To back up a Tru64 Cluster, Data Protector has to be installed one time on the
shared disk and the cluster has to be imported to the Data Protector cell including the
individual nodes in the cluster.
NOTE: Data Protector has to be installed on the shared Disk (/usr/omni) within a
cluster in order to import the cluster & nodes in the cell.
Following are the steps that need to be followed in order to install Data Protector in
a Tru64 Cluster:
NOTE: You must have root permissions on every target system.
3.1. Local Installation
In case there is no Unix Installation Server in the Data Protector cell then the Data
Protector Agent(s) for Tru64 need to be installed locally on the shared disk
(/usr/omni) using one of the nodes in the cluster.
For installing the Data Protector Agent(s) locally, please refer to the topic “Local
installation of Unix Clients” in Chapter 2 (Installing Data Protector on Your
Network) of the “HP OpenView Storage Data Protector Installation and Licensing
Guide” for detailed procedure.
3.2. Remote Installation
Data Protector Agent(s) for Tru64 can also be installed remotely on the shared disk
using any one of the Cluster nodes.
You can install Agent(s) by distributing them from the UNIX Installation Server to
the Tru64 system, using the Data Protector graphical user interface. At this point
you should have the Installation Server for UNIX already installed in the Data
Protector Cell.
For installing the Data Protector Agent(s) remotely, please refer to “Installing Data
Protector Clients” in Chapter 2 (Installing Data Protector on Your Network) of the
“HP OpenView Storage Data Protector Installation and Licensing Guide” for
detailed procedure.
________________________________________________________________________________________________
Backup and Restore of Tru64 Cluster 5