Backup and Restore of Lotus Domino/Notes Cluster using Data Protector

HP OpenView Storage Data Protector
Backup & Restore of Lotus Domino Cluster using Data Protector
9
recovered” database will be recovered to the latest state just like the replica
database. The state gathered after the point in time recovery will be lost.
If the “point in time recovered” database is not to be replicated and recovered to the
last consistent state, then it should never be replicated with the “Pull” or “Push/Pull”
“Replication style” from the restored Domino Cluster Server. This can also be
achieved by following procedure:
• Delete all replica databases of the replicated database from other Domino
Cluster Servers prior to the restore,
• Restore the replicated database as described above,
• Create new replicas to the replicated database on the Domino Cluster Servers
where the replicas were previously deleted.
In this way also the replicas will contain the restored “point in time” state and not the
latest state.
8.4. Restore to a new location
In this case, the database(s) is restored to the new location with the same ID as the
original replicated database and its replicas. In fact the new database is treated as
a replica database. The restored state depends on the type of restore/recovery
you’ve selected in the “Options” -> ”Recovery type” section.
Please refer to the earlier sections, “Restore without recovery”, “Restore with
recovery to the last possible state” and “Point in time recovery” to see in which state
the databases will get restored/recovered.