- Hewlett-Packard Garage Door Opener User Manual

Integrating Oracle and Data Protector
Restoring an Oracle Database
Chapter 1 93
RMAN> RESET DATABASE;
RMAN> exit
Oracle 8i:
Use rcvcat instead of catalog in the above syntax.
Open database after recovery
Opens the database after a recovery is performed.
Reset logs
Resets the archive logs after the database is opened.
Always reset the logs:
• After an incomplete recovery.
• If a backup of a control file is used in recovery or
restore and recovery.
Do not reset the logs:
• After a complete recovery when the backup of a
control file was not used in recovery or restore and
recovery.
• On the primary database, if the archive logs are
used for a standby database. However, if you must
reset the archive logs, you will need to recreate the
standby database.
If you reset the logs when the Restore until option is
set to Now, a warning is displayed, stating that you
should reset the logs only if you use a backup of the
control file for restore.
NOTE Oracle recommends that you perform a complete backup immediately
after a database was opened with the Reset Logs option.
Restoring Oracle Using RMAN
Data Protector acts as a media management software for the Oracle
system, therefore RMAN can be used for a restore.