FW V06.02.00/HAFM SW V08.02.00 HP StorageWorks HA-Fabric Manager Release Notes (AA-RUR6D-TE, September 2004)

About this document
11HP StorageWorks HA-Fabric Manager release notes
2. Download firmware 05.02.00-13 using the Firmware Library option under
the Product Manager Maintenance menu.
3. Back up the director configuration using the Backup & Restore
Configuration option under the Product Manager Maintenance menu.
4. Using the Product Manager, execute a CTP swap:
Note: You must have maintenance authorization rights to access HAFM Product/
Element Manager menu options used in this procedure.
a. From Product/Element Manager Hardware view, verify that an amber
LED indicator is not displayed for either CTP card.
b. Right-click the CTP card you believe to be active. From the right-click
pop-up menu, choose FRU Properties. Verify that it is the active CTP
card.
c. Right-click the active CTP card and choose Switchover from the pop-up
menu.
Note: The director loses its Ethernet connection for a short period during the switchover
process.
When switchover occurs, the green LED illuminates on the backup CTP card
to indicate that it is now the active card.
5. Upgrade the firmware to 05.02.00-13 on each director using the Send option
on the Firmware Library dialog box.
Upgrading firmware on an edge switch from 04.xx.xx to 05.xx.xx
An issue has been identified in release 04.xx.xx if the contents of the nonvolatile
storage (NVRAM) on the CTP become corrupted. Once the configuration has
been loaded, this corruption is not detected until an IPL/IML, power cycle, or
firmware code load. If the NVRAM in the CTP has corrupted contents, the
firmware load can cause the configuration to reset to factory defaults, which could
cause a system outage.