FW 05.01.00 and SW 07.01.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches (AA-RQ7AD-TE, June 2003)

Error Messages
234 CLI Reference Guide for Directors and Edge Switches
Error 154: Invalid
Membership List WWN
The request cannot be
completed because the
WWN does not exist in
the switch binding
membership list.
Make sure that the WWN
deleted matches the
WWN in the Switch
Membership List. Make
appropriate changes and
re-submit the request.
Error 155: Cannot
Remove Active Member
From List
This member cannot be
removed from the fabric
security list because it is
currently logged in.
Fabric security rules
prohibit any device or
switch from being isolated
from the fabric via a
membership list change. If
it is truly the intention of
the user to remove the
device in question from
the membership list, then
there are several
approaches to take. This
request may be
completed most
non-disruptively by
blocking the port (or
physically removing the
device from the managed
switch) to which this
device is attached and
resubmitting the request.
Error 156: Cannot
Complete while Switch is
Online and Fabric
Binding is Active
The switch must be offline
and fabric binding must
be inactive before this
feature can be disabled.
Deactivating this feature
can be disruptive to fabric
operations. Take the
switch offline and
deactivate fabric binding
before disabling this
feature.
Error 201: Change
Authorization Request
Failed
The switch did not accept
the request to make a
change to NVRAM.
Check that all the
parameters are correct,
and reenter the
command. If problems
persist, contact your
service representative.
Table 5: CLI Error Messages (Continued)
Message Description Action