FW 05.01.00 and SW 07.01.00 HP StorageWorks SNMP Reference for Directors and Edge Switches Reference Guide (AA-RQ7BD-TE, June 2003)

SNMP Support
105SNMP Reference for Directors and Edge Switches
FcConnUnitPo
rtControl
INTEGER ResetConnUnitPort(3),
offlineConnUnitPort(6),
onlineConnUnitPort(7), and
portFailure(42501) are the
only set-operations are
supported. Always return
unknown(1) on read.
R/W This object is used to control
the addressed fcConnUnit’s
port. Valid commands are:
Unknown (1) and invalid (2)
are only used as values that
are read.
ResetConnUnitPort (3): If the
addressed connectivity unit
allows this operation to be
performed on this port, the
addressed port performs a
vendor-specific ‘reset’
operation. Examples of these
operations are: the Link Reset
protocol, the Loop
Initialization protocol, or a
resynchronization occurring
between the transceiver in the
addressed port to the
transceiver that the port is
connected to.
BypassConnUnitPort (4): If
the addressed connectivity
unit allows this operation to
be performed on this port,
the addressed port performs
a vendor-specific ‘bypass’
operation. Examples of these
operations are: transitioning
from online to offline, a
request (nonParticipating)
command to the Loop Port
state machine, or removal of
the port from an arbitrated
loop by a hub.
UnbypassConnUnitPort (5): If
the addressed connectivity
unit allows this operation to
be performed on this port,
the addressed port performs
a vendor-specific ‘unbypass’
operation.
(continued in next cell)