FW 05.01.00 and SW 07.01.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches (AA-RQ7AD-TE, June 2003)

perf.thresholdAlerts.counter.addAlert
161CLI Reference Guide for Directors and Edge Switches
Syntax
addAlert name
Purpose
This command configures a new counter threshold alert and assigns it a name. The
new alert is assigned default settings which can then be changed using the other
counter threshold alert commands.
The default settings for a new counter threshold alert are as follows:
■ Ports: None
■ Counter: None
■ Increment: 100
■ Interval: 60 minutes
■ State: Disabled
Parameters
This command has one parameter:
Command Example
Root> perf thresholdAlerts counter addAlert checklinks
perf.thresholdAlerts.counter.addAlert
name Specifies the name of the new counter threshold alert.
This name can consist of any ASCII characters up to a
maximum length of 64 characters. To use spaces or
special characters in this name, put quotation marks
around the name. This parameter is case-sensitive.