FW 05.01.00 and SW 07.01.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches (AA-RQ7AD-TE, June 2003)

Error Messages
238 CLI Reference Guide for Directors and Edge Switches
Error 225: Argument
Does Not Contain All
USASCII Characters
The CLI received one or
more non-USASCII
characters.
Refer to Chapter 2 for
information about the
command parameters.
Check that all parameters
are typed correctly, and
then resubmit the
command.
Error 226: Argument Is
Too Long
One or more parameters
of the specified command
are invalid.
Refer to Chapter 2 for
information about the
command parameters.
Check that all parameters
are typed correctly, and
resubmit the command.
Error 227: Invalid SNMP
Community Name
The value specified for the
SNMP community name
is invalid.
The community name
must not exceed 32
characters in length.
Duplicate community
names are allowed if the
corresponding write
authorizations match.
Specify a valid SNMP
community name, and
resubmit the command.
Error 228: Invalid Write
Authorization Argument
The
writeAuthorization
parameter does not
contain a valid value.
Parameters must be typed
exactly to specification to
be recognized correctly
by the CLI. For more
information, see
config.snmp.addCommun
ity on page 88.
Error 229: Invalid UDP
Port Number
The
udpPortNum
parameter does not
contain a valid value.
Parameters must be typed
exactly to specification to
be recognized correctly
by the CLI. For more
information, see
config.switch.insistDomai
nId on page 96.
Table 5: CLI Error Messages (Continued)
Message Description Action