HP OneView 1.10 User Guide

a. Add two connections to the mgmt 1131 network. When you finish entering the information
for a connection, click Add + to add this connection and reopen the dialog box so that
you can add the connections in the next step.
ValueAttribute
EthernetDevice type
mgmt 1131Network
2.5 (the default value)Requested bandwidth
Auto (the default value)Port
For the first connection, select Primary. For the second connection, select
Secondary.
Boot
b. Add two connections to the vmotion 1132 network. When you finish entering the
information for a connection, click Add +.
ValueAttribute
EthernetDevice type
vmotion 1132Network
2.5 (the default value)Requested bandwidth
Auto (the default value)Port
For both connections, select Not bootableBoot
c. Add two connections to the prod networks network set. When you finish entering the
information for a connection, click Add +.
ValueAttribute
EthernetDevice type
prod networksNetwork
2.5 (the default value)Requested bandwidth
Auto (the default value)Port
For both connections, select Not bootableBoot
d. Add one connection to the FC 1 network. Enter the information shown in the following
table, and then click Add + to add the connection and reopen the dialog box for the next
step.
ValueAttribute
Fibre ChannelDevice type
FC 1Network
2.5 (the default value)Requested bandwidth
Auto (the default value)Port
Not bootableBoot
296 Step by step: Configuring an example data center using HP OneView