HP Insight Control for VMware vCenter Server User Guide (7.3)

• Array Port Speed
HP StoreVirtual—Not applicable◦
◦ HP 3PAR StoreServ—Speed at which the port is connected to the SAN (Gb/s)
◦ HP EVA—Speed at which the port is connected to the SAN (Gb/s)
◦ HP MSA
FC—Speed at which the port is connected to the SAN (Gb/s)–
– iSCSI—Speed at which the network port is connected to the network (Gb/s)
– SAS—Speed at which the port is connected to the host or switch (Gb/s)
◦ HP XP P9000/HP XP—Speed at which the port is connected to the SAN (Gb/s)
◦ HP StoreOnce Backup—Not applicable
• Host Mode
HP StoreVirtual—Not applicable◦
◦ HP 3PAR StoreServ—Not applicable
◦ HP EVA—Host mode assigned to the HP EVA host object
◦ HP MSA—Name of the host's profile
◦ HP XP P9000/HP XP—Host mode assigned to the host group
◦ HP StoreOnce Backup—Not applicable
• Preferred Path
HP StoreVirtual—Not applicable◦
◦ HP 3PAR StoreServ—Not applicable
◦ HP EVA—Specifies whether the path uses a port on the controller that is configured as
the preferred path for the vdisk (Yes, No, No preference)
◦ HP MSA—Not applicable
◦ HP XP P9000/HP XP—Not applicable
◦ HP StoreOnce Backup—Not applicable
• Active Path—Specifies whether the path is active or in standby status
If a path is active and then goes offline, a standby path takes over.
• Path ID—Path ID assigned by VMware
• VMware Disk Identifier—Disk name assigned by VMware
Viewing replications
The replications page displays the following information:
• Source Disk Name—Source replication disk
• Source Array—Array identifier for the local (source) array; displayed only for Continuous
Access replications and not supported for HP MSA arrays
74 Using Insight Control for vCenter