nPartition Administrator's Guide

HP-UX 11i v3 HP-UX is the operating system name
and 11i V3 is the operating system
configuration type.
NOTE: Currently, the parconfig command is supported
only on HP-UX 11iV3.
-pPartitionNumber
Specifies the partition to be modified. PartitionNumber
specifies the unique number (integer) assigned to the
partition when it was created.
NOTE: By default, the core cell of the partition will be
retained back in the recommended configuration of the
partition and the other cells might be deleted. If you wish
to retain back other cells of the partition, use the -c option
for each cell that has to be retained.
-u username[:] -h
IPaddress|hostname
Specifies the required authorization to access a partition
other than the local system (but can also be used as a
loopback access to the local partition).
The -h option is required if -u is used. The colon (:) is
optional and is present for Linux compatibility reasons.
If the -u option is specified, the command prompts for the
password.
username specifies a configured user name on the target
partition.
NOTE: This command is a Web-Based Enterprise
Management (WBEM) Client Application. The -u option
accesses the target partition using a Secure Sockets Layer
(SSL) connection. If errors are reported, check that the
conditions described in the DEPENDENCIES section are
satisfied.
-Xmode
Specifies the mode for configuring the memory of the cell
as Cell Local Memory and Interleaved Memory. The valid
values for mode are:
LORA The memory of the cell is configured as a mix of
Cell Local Memory and Interleaved Memory. The
exact mix and layout is determined by the -Z
option. This is the default.
SMP All of the cell’s memory is configured as
Interleaved Memory (no clm).
-x Specifies the resulting parcreate or parmodify
command to be executed.
NOTE: If -x option is not specified, by default the
parconfig command displays the parcreate or
parmodify command on the standard output. You can
capture the command displayed on standard output, edit
the command if needed and explicitly execute it.
-Z policy
Specifies the policy for determining type of the cell. This
option should only be used in combination with -X option
and mode value as LORA. The valid values for policy are:
256 nPartition Commands