nPartition Administrator's Guide

8 GB memory to that cell. When the partition is booted
again, the cell now has 16 GB of memory, but the CLM is
still 4 GB.
NOTE: If the optional cell attribute celltype and/or
clm_value is specified, the policy rules (specified through
the -Z option) will not be applied to the cell.
-g -hIPaddress|hostname
Allows access to the complex specified by the -h option.
The accessed complex is then considered the target
complex. Access is through the service processor’s LAN
port.
The -h option is required if -g is used.
If the -g option is specified, the command prompts for
the password.
If an error is reported when you attempt to connect using
this option, check to see that IPMI LAN access has not been
disabled on the remote service processor. Access to the
complex through IPMI over LAN can be enabled or
disabled by logging on to the service processor and using
the SA command from the Command Menu.
The -u and -g options are mutually exclusive.
-hIPaddress|hostname
This option should only be used in combination with either
the -u or -g option. IPaddress|hostname specifies the IP
address or hostname, respectively, of the target partition
(-u) or complex (-g).
-n
At least one of the following -n option must be specified:
The valid values for the option are:
-n mincpus:N
Specifies the
minimum number
of CPUs to be
present in the
partition.
mincpus keyword
indicates that the
parconfig
command will select
cells such that the
partition has at least
N number of CPUs.
N specifies the
minimum number
of CPUs and does
not take into
account the CPUs
attached to the cell
specified through
the -c option.
parconfig Command 253