nPartition Administrator's Guide

When using Partition Manager Version 2.0, select the nPartition to which the cell belongs, select
the nPartition→Modify nPartition action, and then configure attributes using the Set Cell
Options tab and the Configure Memory tab.
1. Access Partition Manager.
For details on accessing Partition Manager or other tools, see “Tools for Configuring
nPartitions” (page 165).
2. Select the nPartition whose cell attribute values you want to modify.
3. Initiate the nPartition modify action.
If using Partition Manager Version 1.0, the Partition→Modify Partition action.
If using Partition Manager Version 2.0, select the nPartition→Modify nPartition action.
4. Access the Partition Manager section(s) for configuring cell attributes.
From Partition Manager Version 1.0, select the Change Cell Attributes tab, then select the
cell and click the Modify Cell button. This enables you to configure the use-on-next-boot
value for the selected cell.
From Partition Manager Version 2.0, use the Set Cell Options tab to configure cell
use-on-next-boot values, and use the Configure Memor y tab to configure cell local memory
values.
CAUTION: Memory configured as cell local memory only can be used by operating systems
that support it.
Any memory configured as cell local memory is unusable when an nPartition runs an
operating system that does not support it.
5. After changing attribute values for all the cells you plan to modify, click the OK button.
6. Review all information presented in the Notes and Warnings, the Summary of Changes,
and the HA Checks tabs.
7. Either cancel or proceed with the cell attribute changes.
Click the Cancel button to cancel the changes.
To proceed with the cell attribute changes, click the Finish button or click the OK button.
Setting Cell Attributes 195