HP Superdome 2 Partitioning Administrator Guide

Setting the Mode

• parmodify [-N] next_boot_mode

where:

next_boot_mode has the value of either vPars or nPars

Specifies whether the nPartition has to be booted as a single partition (nPars mode) capable

of running only a single operating system (OS) instance or as one or more virtual partitions

(vPars mode) as defined in the virtual partition database in the partition specification, each

capable of running its own OS instance.

Booting from the CLI

To set the nPartition into vPars mode so that the next nPartition boot allows you to boot

into vPars mode and therefore the vPars environment:

1. Set the mode

# parmodify –p <npar_name> -N vpars

2. After the nPartition is set in vPar mode, the vPar needs to be activated

poweron partition {nPartition identifier}[:{vPar identifier}] (Not

specifying a vPar will result in all of the vPars in the nPartition to be booted.)

Use the pe command to prompt you for the partition to activate:

Example 8-1 Booting a vPar

This command controls power enable to a partition.

Partition Partition

Number Name

--------- ---------

1 nPar0001

2 nPar0002

2:1 nPar0002:vPar0001

Q) Quit

Select partition number: 2:1

The power state is OFF for partition 2:1.

In what state do you want the power? (ON/OFF) on

Booting from the GUI

In the OA GUI, using the left navigation pane, go to the vPar's partition status page. Click on

the Virtual Devices tab:

84 Managing and Booting Virtual Partitions