HP Network Optimizer SDN Application - Microsoft Lync 1.0 Administrator Guide

Figure 17 No information displayed for Source DPID/Port or for Dest DPID/Port
• The switch whose Source DPID/Port information is not displayed in the table is a non-OpenFlow
switch and the flow from this switch cannot be marked with DSCP value, even if the destination
switch is an OpenFlow switch.
• The switch whose Source DPID/Port information is displayed in the table is an OpenFlow
switch and the flow from this switch can be marked with DSCP value, even if the destination
switch is a non-OpenFlow switch.
Values are not saved on the Configuration page after clicking Apply
The Apply button only saves configurations in an active section on the Configuration page. You
can determine if a section is active by its blue heading. A section becomes active if it is expanded
or selected. Only one section can be active at a time on the Configuration page.
If you enter values into non-active sections and click Apply, the values in the non-active sections
will not be saved. For example, in Figure 18, the value 11 is being entered under the non-active
section Hard phone VLANs. If you click Apply after entering the value, only the value under VLANs
with Edge Classifying and Marking (an active section) will be saved.
Figure 18 An active section and a non-active section on the Configuration page
Always make sure the section, containing the configuration you want to save, is active before you
click Apply.
Message from <IP address> was denied in log.log
If the server, running Lync SDN Manager, is not added to Net Optimizer - Lync, this server is seen
as unreachable and Message from <IP address> was denied appears in /var/logsdn/
virgo/logs/log.log for Net Optimizer - Lync.
48 Troubleshooting