Desktop Conversion

Desktop Conversion

HP NETSTORAGE 6000

Kit Contents:

1. Bracket assembly (2)

2. Side panels (2)

3. Panel screws (4)

4. Feet and feet screws (4)

5. Bracket screws (8)

Tools Required:

Phillips screwdriver

A. Use the screwdriver to attach two feet to each bracket assembly.

A. Insert three bracket assembly screws in the holes allotted on the

side of the HP Net Storage 6000, only inserting them halfway.

TIP: For this step, it may be easiest to hang the edge of the unit off the

table.

A.Place the bracket over the set of screws and push it up, so the slots

engage the screws.

Attach the Feet

Insert Bracket Screws

Attach the Bracket

PAGE 1
H P N E T S T O R A G E 6 0 0 0 Desktop Conversion Kit Contents: 1. Bracket assembly (2) 2. Side panels (2) 3. Panel screws (4) 4. Feet and feet screws (4) 5. Bracket screws (8) 1. 5. 4. 2. Tools Required: Phillips screwdriver 3. Attach the Feet A. Use the screwdriver to attach two feet to each bracket assembly. Insert Bracket Screws A. Insert three bracket assembly screws in the holes allotted on the side of the HP Net Storage 6000, only inserting them halfway.
PAGE 2
Tighten the Bracket Screws A.Completely tighten the 3 screws. B. Insert and tighten 1 additional bracket screw in the front of the unit. Attach the Side Panel A.Place the side panel over the bracket assembly and push the panel forward until the back lip is flush with the back of the unit. B. Using a Phillips screwdriver, use two screws to attach the side panel to the mounting bracket. Attach the Other Side A.Repeat steps 2-5 with the other side of the unit.