Neoview Workload Management Services Guide (R2.5)

5. Click [OK] when notified that the connection rule was altered successfully.
NOTE: You can also perform this task using a WMS command. For more information, see the
“ALTER RULE CONN Command” (page 192).
Delete a Connection Rule
NOTE: You cannot delete the system-generated rules that start with the HPS_ prefix. If you
select any of those system-created rules for deletion, they are ignored, and an informational
message is displayed.
To delete a connection rule in WMS:
1. Use either of these methods to open the Configure Workload Management Services dialog
box:
• Select Tools > Configure Workload Management Services from the menu bar.
• Click the toolbar icon:
Configure Workload Management
Services Icon
2. In the Configure Workload Management Services dialog box, use either of these methods
to select the connection rule that you want to delete:
• Under Connection Rules in the tree view, right-click the name of the connection rule
that you want to delete, and then select Delete Rule from the list.
• Click Connection Rules in the tree view, and then click the name of the connection
rule in the Connection Rules Summary pane. Click the [Delete] button at the bottom
of the right pane, or click the toolbar icon in the upper right pane.
82 Configuring Rules