Neoview Workload Management Services Guide (R2.5)

A WMS Commands
This appendix provides syntax, considerations, and examples for the WMS commands. For the
WMS commands that are available only the HP Support, see the Neoview Database Support Guide.
Administrators are permitted to run any WMS command. By default, administrators are users
associated with ROLE.DBA, SUPER.SERVICES, and SUPER.SUPER. Users other than
administrators may execute only these commands:
• INFO WMS
• STATUS QUERIES
• STATUS QUERY
• STATUS WMS
• STATUS WMS DETAIL
• STATUS WMS VERSION
Table A-1 WMS Commands
See these WMS commands:To perform these tasks:
Chapter 2: Getting Started
• “STATUS WMS VERSION Command” (page 258)To display version information for WMS:
• “ADD ADMIN Command” (page 173)
• “DELETE ADMIN Command” (page 209)
• “STATUS ADMIN Command” (page 228)
To add, delete, or display administrators:
Chapter 4: Configuring Services
• “ADD SERVICE Command” (page 185)
• “ALTER SERVICE Command” (page 199)
• “DELETE SERVICE Command” (page 211)
To add, alter, or delete services:
• “INFO SERVICE Command” (page 219)
(or “STATUS SERVICE Command” (page 245))
To display the defined attributes of services:
• “STOP SERVICE Command” (page 259)
• “START SERVICE Command” (page 226)
To stop or start a service:
• “STOP WMS Command” (page 260)
• “START WMS Command” (page 227)
To stop or start WMS:
• “ALTER WMS Command” (page 204)
• “INFO WMS Command” (page 223)
(or “STATUS WMS Command” (page 252))
To alter or display the WMS system
configuration:
Chapter 5: Configuring Rules
• “ADD RULE CONN Command” (page 178)
• “ADD RULE COMP Command” (page 174)
• “ADD RULE EXEC Command” (page 182)
• “ALTER RULE CONN Command” (page 192)
• “ALTER RULE COMP Command” (page 189)
• “ALTER RULE EXEC Command” (page 196)
• “DELETE RULE Command” (page 210)
To add, alter, or delete rules:
171