Neoview Workload Management Services Guide (R2.5)

Associate Rules With Services
To apply the rules that you defined to queries that will run in WMS services, you must associate
the rules with the services.
IMPORTANT: If you do not associate connection rules with services, WMS does not assign
queries to those services but instead assigns queries to the default service,
HP_DEFAULT_SERVICE.
To associate rules with services:
1. Use either of these methods to open the Configure Workload Management Services dialog
box:
• Select Tools > Configure Workload Management Services from the menu bar.
• Click the toolbar icon:
Configure Workload Management
Services Icon
2. In the Configure Workload Management Services dialog box, use either of these methods
to launch the Associate Rule dialog box:
• Right-click Rules, Connection Rules, Compilation Rules, or Execution Rules in the
tree view, and then select Associate Rule from the list:
Rules
• Click Rules, Connection Rules, Compilation Rules, or Execution Rules in the tree
view, and then click the [Associate] button at the bottom of the right pane, or click the
toolbar icon in the upper right pane.
3. Under Rules in the Associate Rule dialog box, select the rule type if it is not already selected:
• Connection option for connection rules
• Compilation option for compilation rules
• Execution option for execution rules
The Rules box lists the existing rules for the selected rule type.
NOTE: To reload the existing rules, services, and associations from WMS, click the [Refresh]
button.
114 Configuring Rules