Neoview Messages Manual (Volume 2) (R2.5)

Recovery If the service exists, check and correct the spelling of the service name and reissue
the command. If the service does not exist, add the service. For more information, see the
Neoview Workload Management Services Guide.
Unexpected programming exception: ComExecDirect: exception detail = 0,
error message = Service service-name exists...use ALTER SERVICE
Cause You tried to add a service that already exists.
Effect The operation fails.
Recovery Specify a unique name for the service that you are trying to add, or use the ALTER
SERVICE command to alter an existing service. For more information, see the Neoview Workload
Management Services Guide.
[WMS]Programming exception: ComExecDirect, Service service-name is
outside the active time
Cause You tried to release a service named service-name that is outside of its active time.
Effect The RELEASE SERVICE command fails to release the service from the HOLD state.
Recovery Either wait until the active time of the service occurs or change the active time of
the service to the current time, and then retry the RELEASE SERVICE command.
Unexpected programming exception: ComExecDirect: exception detail = 0,
error message = service-name is greater than 24 characters
Cause You specified a service name that is greater than 24 characters in length.
Effect The operation fails.
Recovery Retry the operation with a valid service name that is 24 characters or less. For more
information, see the Neoview Workload Management Services Guide.
Unexpected programming exception: ComExecDirect: exception detail = 0,
error message = Use ALTER WMS
Cause You tried to alter the SYSTEM service with an ALTER SERVICE command.
Effect The operation fails.
Recovery Retry by using the ALTER WMS command. For more information, see the Neoview
Workload Management Services Guide.
Unexpected programming exception: ComExecDirect: exception detail = 0,
error message = Use HOLD WMS
Cause You specified SYSTEM for the service in a HOLD SERVICE command, which is
disallowed.
Effect The operation fails.
Recovery Retry by using the HOLD WMS command. For more information, see the Neoview
Workload Management Services Guide.
Unexpected programming exception: ComExecDirect: exception detail = 0,
error message = Use INFO WMS
Cause You specified SYSTEM for the service in an INFO SERVICE command, which is
disallowed.
Effect The operation fails.
96 Neoview Workload Management Services (WMS) Messages