Neoview Messages Manual (Volume 2) (R2.5)

Effect The operation fails.
Recovery Retry the operation with an interval that is between 5 and 300 seconds. For more
information, see the Neoview Workload Management Services Guide.
Unexpected programming exception: ComExecDirect: exception detail = 0,
error message = Invalid WAIT_TIMEOUT...must be between 0 and 1440
Cause You specified a waiting timeout value that is not between 0 and 1440 minutes.
Effect The operation fails.
Recovery Retry the operation with a waiting timeout value that is between 0 and 1440 minutes.
For more information, see the Neoview Workload Management Services Guide.
Unexpected programming exception: ComExecDirect: exception detail = 0,
error message = No valid connection with WMS
Cause You issued a WMS command, and the WMS ZQSDLL could not identify a WMS
process on any of the segments during a FastFetch() call.
Effect The command fails.
Recovery Contact your HP service representative.
Unexpected programming exception: ComExecDirect: exception detail = 0,
error message = query-id is greater than 255 characters
Cause You specified a query ID that is greater than 255 characters in length.
Effect The operation fails.
Recovery Retry the operation with a valid query ID that is 255 characters or less. For more
information, see the Neoview Workload Management Services Guide.
[WMS]Programming exception: ComExecDirect, Rule name cannot contain
blank(s)
Cause The name of the rule contains one or more blank spaces.
Effect The ADD RULE command fails to create the rule.
Recovery Remove the blank spaces in the rule name, and then retry the ADD RULE command.
Unexpected programming exception: ComExecDirect: exception detail = 0,
error message = SEGMENT must be greater than 0
Cause You specified 0 for the segment in the STATUS MEMORY command.
Effect The operation fails.
Recovery Retry the operation and specify a segment greater than 0. For more information,
see the WMS chapter in the Neoview Database Support Guide.
[WMS]Programming exception: ComExecDirect, Service name cannot contain
blank(s)
Cause The name of the service contains one or more blank spaces.
Effect The ADD SERVICE command fails to create the service.
Recovery Remove the blank spaces in the service name, and then retry the ADD SERVICE
command.
Unexpected programming exception: ComExecDirect: exception detail = 0,
error message = Service service-name does not exist.
Cause You specified a service that does not exist.
Effect The operation fails.
95