Neoview Messages Manual (Volume 2) (R2.5)

Effect The operation fails.
Recovery Retry the operation with a comment that is 256 characters or less, including spaces.
For more information, see the Neoview Workload Management Services Guide.
Unexpected programming exception: ComExecDirect: exception detail = 0,
error message = For this command WMS must be running on primary segment
Cause You issued a WMS command, and the WMS ZQSDLL could not find an executing
WMS process on the primary segment (that is, segment 1).
Effect The command fails.
Recovery Contact your HP service representative.
Unexpected programming exception: ComExecDirect: exception detail = 0,
error message = Invalid ACTIVE time...end time earlier than begin time
Cause You specified an end time that is earlier than the start time.
Effect The operation fails.
Recovery Retry the operation with an end time that is earlier than the start time. For more
information, see the Neoview Workload Management Services Guide.
Unexpected programming exception: ComExecDirect: exception detail = 0,
error message = Invalid ACTIVE begin time...could not locate begin time
Cause You specified an invalid start time.
Effect The operation fails.
Recovery Retry the operation with a valid start time from 00:00 to 23:58. For more information,
see the Neoview Workload Management Services Guide.
Unexpected programming exception: ComExecDirect: exception detail = 0,
error message = Invalid ACTIVE begin time...Invalid hour specified
Cause You specified an invalid hour for the start time.
Effect The operation fails.
Recovery Retry the operation and specify an hour from 00 to 23. For more information, see
the Neoview Workload Management Services Guide.
Unexpected programming exception: ComExecDirect: exception detail = 0,
error message = Invalid ACTIVE begin time...Invalid minutes specified
Cause You specified an invalid number of minutes for the start time.
Effect The operation fails.
Recovery Retry the operation and specify a number from 00 to 59 for the number of minutes.
For more information, see the Neoview Workload Management Services Guide.
Unexpected programming exception: ComExecDirect: exception detail = 0,
error message = Invalid ACTIVE end time...could not locate end time
Cause You specified an invalid end time.
Effect The operation fails.
Recovery Retry the operation with a valid end time from 00:01 to 23:59. For more information,
see the Neoview Workload Management Services Guide.
Unexpected programming exception: ComExecDirect: exception detail = 0,
error message = Invalid ACTIVE end time...Invalid hour specified
Cause You specified an invalid hour for the end time.
93